Fitting the Utility’s port side planking — and a little more progress on the Zip

Having previously used the starboard side planking as a template to draw and cut the port side, fitting the port side planking was relatively quick and simple. Busy days full of other obligations have meant that I’ve had to work on the boat incrementally... 20 minutes here, 45 minutes there... but, its getting done.

Thanks to a little help from my daughter, I’m now most of the way through driving the screws to hold the planking down. The new DeWalt titanium drill bits I bought have been a real pleasure to work with, particularly since my older ones had become almost too dull to use.

Dry-fitting the forward port side planking.

February brought with it an unusual amount of snow this year. In addition to school cancellations, there were a few days when I got snowed-in at home. I took advantage of these days to draw out the construction drawings for my Zip on a big sheet of eucaboard.  I drew the frames out as they would overlap one another, based on their shared x,y axis & set-up level. This will be a great reference for checking  the frame parts for accurate shape & for assembling the frames. It is also a very useful tool for checking the relative dimensions of various aspects of the hull.

My Zip construction drawing on a big sheet of eucaboard.

Last Christmas, I received a copy of How to Fiberglass Boats, by Ken Hankinson, along with the accompanying DVD. I finished reading it recently, and I’ve enjoyed watching the DVD. It’s useful information for those, like me, with minimal experience at working with fiberglass. It takes a lot of the mystery out of the process, and its very helpful to watch someone else actually doing it. 

Additionally, the book is very enlightening about precautions to take when working with epoxy.

With any luck, Ill be able to fiberglass the Utility’s hull before summer.

Read More..

Bottom port forward is dry fit

On Fathers Day, I finally completed dry-fitting the bottom planking on the forward port side of the boat. Im very happy about that.

Port bottom planking, dry-fit with screws and washers.

The fitting started off wonderfully at the aft end, where the planking joins along the centerline of the keel. By the time I finished at the bow, however, there were some spots where the fitting was not as good as Id hoped. These spots can be filled with thickened epoxy, of course. Still, I wish the fitting had been better.

About midway along the keel, there is an open seam approximately 18 inches long, and about 5/32" at its widest point. There was also supposed to have been a transition joint just forward of the end of the keel. I did not pre-plan for this, and as a result, I kind of messed it up a little bit. 

5/32" gap along the centerline of the keel.

The missed transition joint.

In retrospect, I think both of these mistakes could have been avoided if I had overlapped the planking along the centerline of the keel, and trimmed the whole length to fit as I went.

There is another small gap between the bottom planking and the side planking at the stem. 

Another small gap up forward.

My plan is to use epoxy thickened with mahogany sawdust (ie: Wood Flour) when I glue this panel on. From what Ive encountered so far, this mixture seems to absorb impact better than epoxy thickened with #2 silica (which seems more brittle). The thickened mixture will fill in these gaps, and I believe that in the end it will all be just fine.

Read More..

Butt blocks on the port bottom

Not a lot of visible progress since the last post... mostly sanding throughout the last week. However, I did get the backing blocks attached for the last butt joint, where the two bottom panels on the port side will meet. Here are a few photos:

Deep-reach C-clamps are ideal for attaching butt blocks.

Read More..